Wacker Neuson BH 23 Manual do Operador descarregar pdf (Página 22)

Description

T00931GB 20

4.3 Transport to work site

Conditions:

∗ Only use appropriate lifting gear with a minimum load-bearing capacity

of 30 kg when transporting the Wacker equipment.

∗ Always switch off motor during transport!

∗ Tie down the Wacker equipment when transporting it on the load-

carrying surface of a transport vehicle.

Note: Also refer to the specifications in safety instruction.

4.4 Description of function

4.4.1 The engine, which is flanged to the crankcase and is held in place by

3 screws. drives the percussion systemover a gear transmission and

a connecting rod. The engine torque is transmitted by means of a

centrifugal clutch.

4.4.2 The centrifugal clutch interrupts the flow of power to the percussion

system at low engine speeds, thus allowing for a perfect idling of the

engine.

4.4.3 The engine can be switched off with the stop button or the fuel tap.

4.4.4 The drive engine works according to the 2-stroke principle, and is

started mechanically by means of a recoilstarter. The engine is air

cooled and the air necessary for combustion is directed through the air

filter.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 37 38

Sem comentários

Wacker Neuson BH 23 Manual do Operador Página 22