Wacker Neuson EHB 10 series Manual do Operador descarregar pdf (Página 34)

Operation EHB 11

7.3.4 Tool holder for tool with spline shaft

Inserting tool

1. Clean tool end.

2. Turn lock bolt by 90°.

3. Push tool into the tool holder as far as it will go.

When inserting a chisel, make sure the notch on the tool points towards the

spline shaft.

4. Turn lock bolt back by 90°.

5. Check to see if the tool is locked by pulling on the tool.

Removing tool

1. Turn lock bolt by 90°.

2. Remove tool from the tool holder.

3. Return lock bolt to original position.

Item Designation

1Tool

2 Lock bolt

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 53 54

Sem comentários

Wacker Neuson EHB 10 series Manual do Operador Página 34